Before & After Photos

A homeowner in Rye, New Hampshire, recently had their home tested for radon gas, revealing a level of 7 pCi/L. Since levels above 4 pCi/L necessitate the installation of a radon mitigation system, this finding was particularly alarming, given that the homeowner's daughter's bedroom is in the finished basement. To address this urgent health concern, they reached out to Erickson Foundation Solutions for the prompt installation of a radon mitigation system to protect their residence.

Our System Design Specialist, Liam FitzPatrick, recommended installing our radon mitigation system, along with our Erickson Care Club service.  The installation team began by creating an extraction point via a small circular cut in the basement's concrete floor for the radon mitigation system. They then attached a radon pipe to this point, extending it to the exterior of the home, where they mounted the radon fan on the side. They routed additional piping from the fan along the side of the house, extending it above the roof to avert radon re-entry. Following the operational integrity test of the fan, the homeowners were given a charcoal test kit to measure the radon levels after about one week.

The installation of the radon mitigation system has safeguarded this family from the hazardous gas.

This homeowner in Gloucester, Massachusetts was experiencing high radon levels in their home. The homeowner would like to reduce these as much as possible. They decided to call EFS for a free inspection.

A design specialist arrived at the home and inspected the basement. The design specialist recommended that the homeowners have EFS install a radon mitigation system as well as a Clean Space Encapsulation.

A homeowner in Gloucester, Massachusetts became concerned about the radon levels in their home following an understanding of basement systems. The radon test results indicated levels between 6-9 pCi/L, exceeding the EPA's recommended action level of 4 pCi/L. In an effort to reduce the radon levels, they contacted Erickson Foundation Solutions.

Our Design Specialist, Tom Armano, recommended installing a radon mitigation system with a fan moisture guard and exterior aesthetic package. The installation team initiated the process by creating an extraction point through a small circular opening in the basement concrete floor for the radon mitigation system. A radon pipe was then affixed to this point and extended to the home's exterior, where the radon fan was mounted on the side. Additional piping from the fan was routed alongside the house, extending above the roof to prevent radon re-entry. After testing the fan for operational integrity, the team provided the homeowners with a charcoal test kit to reassess the radon levels after approximately one week.

With the proper precautions now taken, this homeowner has peace of mind that his home is safe from radon.

A homeowner from Concord, New Hampshire had an extremely wet basement. Even with a sump pump already installed, water still made its way through the foundation. The homeowner is sick of dealing with the seepage and doesn't want the next owner of the home to have the same experience. She reached out to Erickson Foundation Solutions looking for a permanent solution for her leaky basement.

One of our Design Specialists, Anthony Brancato, went to the house to provide a free home inspection. After taking a thorough look at the basement, Anthony recommended installing our WaterGuard perimeter drainage system to the already existing sump pump. Although the sump pump works properly, it is unable to waterproof the basement on its own due to the amount of water in the soil surrounding the foundation. The WaterGuard perimeter drainage system actually allows the water to flow right into the system, and directs it right to the sump pump. By letting the water flow right into the perimeter drainage system, water doesn't build up on the outside of the foundation, which is what causes the leaks. 

With the system in place, a waterproofed basement has been created. The homeowner can now have peace of mind while she lives in the home and goes through the home selling process.

A homeowner in Nashua, New Hampshire has lived in his home for over 40 years. Several years ago, he noticed that his basement would leak. In order to fix this, he had a sump pump installed. This pump isn't working as it was intended to, resulting in the basement flooding. Looking for a permanent solution keep his basement dry; he reached out to our Erickson team.

Our Design Specialist, John Prince, recommended installing WaterGuard perimeter drainage, SuperSump sump pump, and FlexiSpan crack sealant. Our crew started installing this waterproofing system by chipping our concrete along the border of the basement floor to make space for the WaterGuard drainage. This system captures water at the perimeter of the basement before being exposed to the walls or floor. The water collected then flows to our SuperSump sump pump. A new basin was created for the sump pump to sit in since the previous basin was not in the ideal spot. A feed line was installed connecting the old basin to the new basin in order to allow the new sump system to pump out the unwanted water. Once these systems were installed, they were cemented in place. An exterior discharge line was then installed to the sump pump to direct water safely out of the home. IceGuard was installed to the discharge line to prevent the pipe from freezing, which prevents sump pumps from backing up and flooding. Lastly, FlexiSpan crack sealant was used to seal a large crack in the basement wall. This sealant stops water from making its way through the crack, and is able to adjust to settlement, making it a long-lasting solution.

With the job now complete, crew lead Ryan Champagne went over a final walkthrough with the homeowner. He was thrilled that he would never have to deal with the annoying cleanup process again!