Before & After Photos
Click on a photo to enlarge.
Radon Fan Replacement Completed in Southport Home
Before
The existing radon system had an older fan that had never been serviced, while radon levels were averaging between 5 and 10 pCi/L.
After
The older radon fan was replaced with a new fan, restoring reliable operation of the existing mitigation system.
Radon Mitigation System Installed in Goshen Slab Home
Before
The home had a radon level of 2.2 pCi/L with no mitigation system in place. The structure is slab-on-grade, with an inaccessible crawl space below.
After
A single-pipe radon mitigation system was installed, with the pipe routed through the right side of the home to provide proper venting.
Radon Mitigation System Installation in Lakeside
Before
The home had an elevated radon reading of 10.5 pCi/L. The unfinished basement and crawl spaces presented multiple potential areas for radon entry, requiring a system designed to address each section.
After
The four-point radon mitigation system was installed to draw radon from the main foundation and both crawl spaces. The completed system includes an exterior fan and vent piping routed along the home's exterior. A pressure gauge was installed on the system to help monitor operation.
Radon Mitigation System Replacement Planned for Lakeside Home
Before
The existing radon fan is mounted outside the bedroom and creates unwanted noise inside the home. The current system will need to be removed or disconnected as part of the planned relocation.
After
Install a replacement radon mitigation system near the boiler, with exterior piping routed above the Bilco doors and upward between the windows above the lower metal roof. Reuse existing PVC piping where appropriate, install anti-vibration clamps and a muffler to help reduce noise, and cap off the old exterior pipe.
Multi-Foundation Radon Mitigation System Planned for Botsford Home
Before
The home tested at 7.0 pCi/L in the basement and 4.5 pCi/L on the upper floors. Multiple foundation sections and an unsealed chimney opening created additional considerations for effective radon mitigation.
After (Planned Work)
A multi-point radon mitigation system will be installed, the chimney opening will be sealed with concrete, and the system will be routed to the left rear side of the home to provide long-term radon reduction.
