Before & After Photos

Before

The home owners are completing renovations to the upper level of the 2 story home. They have included proper attic insulation work to help make the older home more comfortable and energy efficient.

After

Spray foam was used on the lower portion of the attic decking to provide an air/vapour barrier between the attic and the living space. This barrier is a vital part of attic insulation as it will not allow the heated/cooled air below to escape into the attic above. Cellulose insulation can then be blown-in to complete the process.

If you are planning to upgrade your home consider giving Advanced Basement a call to discuss options- we can help!

The home was built in the mid 1980’s and had blown-in insulation. The insulation was uneven and some spots were only a couple inches thick while other spots met R60 values. Inspection reveled a proper vapour barrier between the ceiling of the upper floor and the attic. Unfortunately for the home owner the barrier contained many holes and slices rendering it useless.

Advanced Basement was called to remove the old insulation, repair the vapour barrier and add blown-in cellulose through out to R60 recommended values.

If you suspect your attic insulation is not at the recommended R value, call Advanced Basement Systems for an inspection and quote to repair.

Our product Mold-X2 is a special two-part system of botanical and stain remover. This means we are killing the mould and then also removing it from the lumber! The result are essentially immediate. The product can also be used on concrete. 
Great job by our installer Logan here! This attic is well on its way to being dry, safe and comfortable- helping this home save money on energy bills.

Before:

When cold weather hits, proper attic insulation is important to keep your home warm and energy efficient through the winter. Adding more insulation on top of old may not give you the results you need to keep the home comfortable. A continuous vapour barrier under the insulation is a vital component to keep warm air in and cold air out.

After:

Advanced Basement Systems will remove the old insulation then seal all openings before adding the required amount of blown-in cellulose. 17 inches of insulation is the recommended amount to bring the R-value up to R60.

Call Advanced Basement Systems for all your home insulation needs!

A properly insulated home requires a complete vapour barrier on the inside of insulation. Holes or cuts in the barrier will allow conditioned inside air to move out of the home. Common perforations in the attic are electrical fixtures (pot lights!), plumbing pass throughs and structural components or chimneys.

Advanced Basement Systems was called to inspect the attic of this home. It was discovered that all the light fixtures were not properly sealed to the air barrier. The old insulation was removed, the fixtures sealed and new blown-in cellulose was added to a thickness that provides the recommended R-60 insulation value.

Give Advanced Basement Systems a call if you would like your attic inspected!